Livorsi DTS Controls Manual de usuario descargar pdf (Pagina 10)

Livorsi DTS Controls- Single/Dual Engine Installation APRIL 2012 Page 10 of 12

Control Connection Harness Connection

Starboard Shift Potentiometer “LEVER 1”

Port Shift Potentiometer “LEVER 2”

Starboard Throttle Potentiometer “LEVER 3”

Port Throttle Potentiometer “LEVER 4”

1. Connect the “LEVER 1” connector on the DTS command module harness to the

starboard control’s shift potentiometer

2. Connect the “LEVER 2” connector on the DTS command module harness to the

port control’s shift potentiometer

3. Connect the “LEVER 3” connector on the DTS command module harness to the

starboard control’s throttle potentiometer using the adaptor harness

(P/N 89-891963A01).

4. Connect the “LEVER 4” connector on the DTS command module harness to the

port control’s throttle potentiometer using the adaptor harness

(P/N 89-891963A01).

5. Connect the trim adaptor harness to the DTS command module harness.

6. Connect the bullet connectors on the trim adaptor harness to the trim

connections on the control.

7. Connect the six bullet connectors on the trim adaptor harness to the individual

trim switches on the dash or console. (optional)

8. Connect the start/stop switch (optional), lanyard stop switch, and key switches to

the appropriate connections, as shown.

9. Make all other DTS command module harness connections following the

instructions included with the DTS Command Module kit.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Livorsi DTS Controls Manual de usuario Pagina 10